Your shopping cart is empty.
Hi,
Does someone know if it is possible to have a finer resolution for device parameters?
When I look at the Min/Max values from, let’s say rack-macros, I see that they go from 0.0 - 127.0
To it would be great to have a finer resolution for these parameters. 0.1 for example.
On Push (1&2) I could do this by pressing SHIFT.
Push 2 has 14 bit encoders. I am not sure about Push 1.
But I also don’t know if you need 14 bit encoders to do this.
World be great if would share a thought on this
Cheers
Comments
You can set the range to lower than the full range.
So turning a knob from its min 0 to max 127 could be set to adjust a param by a smaller amount than the param's own min / max, which would give you a more fine control.
The 'Parameter' mapping type for example, has minimum and maximum options which you can use for this.
Thank you for your answer.
With this solution i do get smaller steps but I don’t get the full range …